OEM 03 Cobra radiator thickness?

[Snkypete]

Anyone know the specs on the radiator? I held off purchasing the Fluidyne unit because there is a significant savings with the 03 cobra piece....but I can't find out if it's a 1 or 2 core unit and what the size is.

Any insight is appreciated.....

[a Bill]

Single row 1-3/8" flat tubes, 25"x17" core. I have a new one sitting here waiting for warmer weather so I can measure other stuff if you need it.

[Snkypete]

Awesome, thanks for the help.

[Dyno Dan]

Hey guys, has anyone successfully installed one of these on a 99+ GT? I've got a 2000 GT with a D1sc Procharger and I run a small "mushroom" style K&N directly on the blower. The filter is butted right up to the plastic fan shroud. If the Cobra radiator is any thicker, I'll have to figure something else out in terms of the blower inlet.

Side note, a friend of mine asked me for the p/n on my filter, as he wanted to intsall one with his Procharged 03 GT. His fan assembly has a connector / module built right into the plastic shroud. The filter would NOT sit because of this change.

[Snkypete]

Plenty of people have put them in 99+GT's - Randy believes it is a direct bolt in. You will need to change the plug if you use the 03 cobra fan however.

I did find out that it's a 1-3/8 core whereas the Fluidyne is a twin 23mm core so that made up my mind.

[Peeyellowstang]

ok Pete, stupid question here but which one are you going with? I might look into this if its cost effective, a little extra cooling never hurts.


Jeremy

[Snkypete]

I ended up with the Fluidyne. My logic was...if they were the same, great save money...but for the additional cooling capacity, I'll spend the money....

[Big Scott]

They also work very well on MN12's and we have a tighter front area then the Stangs.

http://members.tccoa.com/legendx/cobrarad2.jpg

http://members.tccoa.com/96goldbird/radiator/radiator%20top%201.jpg
This would be the upsidedown version.

-Scott