- neutral rev limiter 03 cobra
- Dyno Tune Questions with AED Blower
- where can I adjust total timing?
- 96GT42 Value File
- Weird stutter??
- Tuning a 96GT42 ProM 90mm Maf
- SCT mass air sensor
- 03 intercooler pump and fan
- Having trouble finding these parameters in myZXA4 file
- Found my studder....99 Cobra MAF on a 00 Focus....
- Load Table for Focus
- Humming noise after decel
- What the best aproch on tuning for WOT and heavy load?
- Trying to load new computer file
- I have an idea.....not sure if it will work....
- BAP AND BAS Users-hobbs switch
- Article on EGR valves
- A/F at Boost before WOT
- Pulling fuses with?
- SAE Article: Comparison of Air Meter Interface Strategies for
- What does the EEC use for shifts?
- Autotap users Q
- SCT Logger... and Questions! :)
- LM-1 RPM question
- Stalling issues
- Question for the SCT Folks !!!
- Converter Shudder at 3-OD
- How to correct for lean cond. at tip-in from idle?
- Transfer function Help
- SCT and dyno questions.
- Speedometer Recalibration Gears
- SCT Raptor
- Melted MAF
- Transfer Function Curve
- What should I tune by LM-1 or Short Term Trim?
- High altitude pinging
- Dumb question: where do I get the base file from?
- A/F ratios not stable
- PRO-M conversion.....
- Info for SCT guys about '98 GTs Fuel Fuse.
- Pro-M 95 died! I NEED a new MAF ASAP!
- Need help soon !!!
- Tuning VT cams - stalling
- Questions, questions... Need some answers !!!
- Checking In
- LM-1 ???
- data from LM-1/AutoTap
- What is everybody using for datalogging and how much?
- Okay, Follow Along While I Speculate (MAF)...Kinda Long
- SCT Mass Air Sensor
- Rec. Chip & Cable....
- SCT chip dealers in CT?
- Speedometer
- Raptor Info and updated .exe
- Raptor.exe update
- P1151 Code
- Air Charge Temperature sensor where is the best place?
- Any reason why the SCT software says its not registered yew?
- I need wideband info for the Raptor
- Hard Hot Start Problems - Reared its ugly head again
- Going open loop on low load. Help Please.
- Slow Loading SCT article in Mustang Enthusiast Jerry & Chriss tuning at Bristol Dyno
- Anybody figured out how to integrate the LM-1 with the Raptor yet?
- Base tune won't get me to the dyno-Focus
- .dif extentions
- My laptop crashed
- Powerstroke Tuner?
- Going Open Loop while Decelerating in 3rd & 4th gear. Please help
- Raptor Trim units questions
- Top end limiter still there!
- First log with Raptor...some questions
- serial cable question
- Interpreting fuel trims on Raptor
- Autotap users
- Raptor software suggestions
- Datalogging with Raptor... Questions about pauses in logs.
- EGR turned off via mail order tune?
- colder plugs with mail-order tune (pcm flasher)?
- isc_neutral_and drive_air
- Checking In
- Raptor 1.0.8
- Alternator cut-out: Long term effects?
- Raptor v1.1.0
- Short Term Fuel Trim reading Raptor Vs Autotap
- Raptor v1.2.0, big update
- LM-1 logging in the Raptor?
- 36# Injectors
- SCT / Supercharger
- Please explain units in used Raptor Load
- Can the serial port filter be bought at electronic stores?
- AEMs UEGO Wide Band Monitor
- Update.. PLX M300 & Raptor logging!
- Raptor ignoring PCM code??
- Do we need a separate Raptor Forum?
- What happened to the Spark Source PID in 1.2.0?
- Please explain units used in TB position.
- Raptor 1.2.0 Bug Report I can get the program to crash every time.
- Which functions to change for two stage limiter?
- Guidance for fuel pump PID tuning.....
- Can I flash the chip while plugged into the ECM?
- Please explain Spark Source used in the Raptor Software
- License keys
- Surging problems..
- Going From 14lbs to 20lbs (Vortech to Novi 2k) Tunning Suggestions Inside Please!
- Tuning Maf curve on 01 4V
- Safe to make a run with adaptive learning off?
- Cold Idle problems
- New Raptor USB Driver
- Raptor operation
- Raptor / screen freezes
- ok, stupid question, but wanna get this right.
- Auto Tap 2.05 & Short Term Trim
- Raptor driver update
- Shift duration, shift torque reduction (4R100)
- I have sensor guide program that Autotap gave me
- spark_adder_for_A/F_when_open_loop
- Bad 02 sensor?
- Going blow-thru
- SCT Guys how do you want us to report bugs and can you give us weekly updates?
- Cobra - Fuel Tuning
- Raptor Bug report
- Change values w/ O/R exhaust
- Did not get cable for my switch chip. Which bank does it program?
- Need help SCT guys...
- Saving tune from my chip...
- short_term_trims @ idle
- Software crashes on startup... HELP!
- registration key
- JeeeeZ! I still can't get comms with my computer!!!!
- logging with adp off/are my 02 ok?
- Idle issues
- SCT guys... I may need new database
- Cobra Lightning MAF Upgrade
- Raptor DL of the 02 on dyno and 1/4 pass..couple questions
- Need Some Help...Not Running Well
- LM1 input to Raptor. Need Math Wiz Help!
- TP 500=what for voltage?
- Surge At WOT
- Not Original Car/Programming
- Swutching from a 2" pully to a 6" where to start???
- Chip advantage for dyno tune
- 24# to 30#
- Engine dies at 6000rpm and above.
- Charley issues
- Raptor 1.2.1 update
- WideBand????
- Hooking up wide band to raptor?
- Fuel Pump Tuning
- blkhors, try this
- bkt
- Determining Injector Pulsewidth with Raptor
- Blue or Gold Superchips chips...
- Truck dies when changing tunes
- What not have a data base of tunes?
- Whats too low for target slip time?
- Air Meter Transfer Function??????
- Parallel burner power supply help
- CEL help needed.
- SCT help needed.
- question on tuning new mods
- Detonation!!!
- anyone using a usb to serial adaptor
- Need values for 50# injectors
- Noob in the learning stage
- Returnless fuel system ?
- Software installation problem
- Still seem to have some surging..
- Knock/Raptor
- check...
- Tuning with alcohol injection
- Hanging throttle during decel
- base tune way off??
- a/f ratio
- what does the computer do to adjust for a/c?
- Brandon.Alsept
- Need HELP! with MAF transfer and trims!
- My analog function does not work.
- NE Ohio Raptor owner?
- Raptor divice not found
- RAPTOR graph?
- Datalogging?
- EEC-V 104 Pin Harness Extension
- SCT Mass Air Transfer Function
- Database folder empty??
- Made a new X-fer Funct...Have some ?'s
- re-installing software?
- My car will not go into open loop at WOT!
- Calling Jerry W - Aviator Fuel Pump
- I need 38.5# fuel injector values.
- What is 16 in Spark_source?
- A/C Delete & High Speed Fan
- 60# injectors?
- knock Sensor 101
- Engine swap- 99 Romeo-> 00PI Winsor
- Raptor 1.2.2.0 Update
- cobra fuel pump/ 30lb injectors and pro-m 80
- Wide Band behavior on analog 1.
- SCT meter on sale
- Lost base file!!!!!!!!!!!
- Raptor Analog Pinout
- fuel pressure ?
- What will I need to do
- 60# Injector Files??
- Does Autometer electronic guage have an analog out?
- Can I transfer my racer package to some one else ??
- Tunning question - '03 w/ Procharger
- Can anyone convert a AMZ2 file to a AMZ1?
- MJ Chip MAF Xtender
- Warm Start Tuning Question
- Base Tune Problem - Bucking
- 2 more pounds of boost?
- SCT GUYS - You may want to see this.
- dyno tune time ?
- NEED HELP! Can't go Open Loop!
- Full J-Mod users, 1-2 around town?
- Value files for OEM MAF's?
- Boost a Pump wiring on a 04 Cobra?
- Raptor Question, probably not a bug...
- File marker on an analog port.
- Why do I have 2 Fuel_injector_breakpoint ?
- SCT Help! Car will not go closed loop.
- No Idle - Base Tune
- Something is seriously wrong!!!
- Suggestion for FAQs
- spark_retard_for_act clarification
- Big Air MAF; now what?
- What change to fuel pump parameter for Boost-a-pump?
- maf transfer funtion help
- bOOST-A-PUMP SUPPLEMENT FOR 99GT
- Resetting the Flasher after Ford Recall
- Ported heads & low load/RPM timing
- Wide band question
- Bailey AFM-1 Pinout needed
- Fuel trim question?
- adaptive_control_switch ?
- Is there anywhere to download
- SW Key
- Raptor still freezing up my Laptop
- STFT not transferring to LTFT
- Closed Loop Operation
- MAF xfer or something else?
- Raptor 1.2.4.0
- Do I need a Marauder maf?
- Stalling Question - What Corrections?
- Value files request
- Any SCT tuners in texas?
- Raptor Database UPDATE
- Simple maf_transfer_function question. Pleas go over this
- Idle problems continue. Bought Raptor datalogger to help. Need a little help.
- maf transfer funtion help